Fuzz on top of head touched the headliner. These rear seats fold up against the back wall of the cab, instead of down into the cab corner area like the 2 door Rangers. Now the passenger side is failing again after only 2605 miles and Ford does not want to warranty the belt because it was replaced 14 months ago. You will have to run a Tap through some pre drilled holes in the bottom of the seat frames. I believe there is a defect in my vehicle or the seat belt design. Il existe plusieurs types de dossiers inclus dans le rapport, y compris : l'une des formes les plus courantes de fraude automobile sur le marché des voitures américaines d'occasion concerne la reprogrammation du compteur kilométrique. Sweet, thank you Also, Do I need to get them from a 2dr ext cab explorer if I have a 2dr ext cab ranger?? They said it would be at least the middle of September.
The first replacements were for all 4 seat belts, prior to warranty expiration at 49,499 miles. This seat came out of a truck with rear doors. Dans certains cas, les rappels de véhicules visent à corriger les défauts de fabrication potentiellement dangereux. No burns, rips, tears or stains. . I asked if Ford would be liable if something happened.
They also verified the part was on back order, but did not know when part would be supplied to dealer as Ford did not manufacture part. I am concerned for my safety! Larry kramer would not give me any straight answers. I asked what I was suppose to dosince I was going on vacation. The vehicle was not repaired. Our grandchildren mostly 4 and 10 year old boys will sit in the front center seat and fasten the 2 point seat belt about them; adjust it to the proper length; during travel the child moves about the seat slightly; during this normal movement the seatbelt adjustment will loosen on its own.
The police report and the vehicle identification number was not available. The passenger side front seat belt has been replaced on this vehicle 3 times since Nov of 2003. This forces the seat back into a very upright position. Tonight I just installed a set of bucket seats out of a 2004 ranger extended cab into my friends 1994 extended cab. Larry kramer is the engineer representative with Ford. I reported this condition to Ford Motor Company. I am just now taking a break from the initial all tack welds fit up of putting 03 Stang seats in mine.
They also would not give me the name of the regional contact for Ford, so I contacted Ford customer service. The front center 2 point seat belt will not remain in the fully adjusted position during normal operation of the vehicle. I took truck to dealer 08-06-99, dealer said seatbelt retractor was broken, they would have to order. The seat tracks are welded to the 2004 seats so there was no swapping them. It looked awful close to fitting so I did some measuring. She said she could not answer that, but she would put my question in the message to the Ford division manager.
The failure mileage was 160,000. I had to swap the seat belt receiver from his old seats to the new ones, that was it and remove the seat belt pretensioners. I explained the aforementioned to her. I could be wrong, but I own both styles of truck and I dont see much of a resemblance. I had gone by the dealership 4 times, and can't get any of these taken care off.
The 2000 seats had all the holes in them already to bolt up to my 1997 tracks, they just weren't threaded yet. Submitted by Merc All of these will bolt directly to your factory tracks if you have either Buckets or split-bench. The total mileage driven since that first replacement is 9023. I used the original mount holes due to the reinforcement underneath the floor pan around them. The holes are already there but unthreaded. The current mileage was 220,000.
As a consequence he could not properly view the road-way, which caused a vehicle crash. They said it was Ford's problem. For sale is a Passenger Side rear seat out of a 1999 4-door Ford Ranger. He was ready to fight, I do'nt know what to do with this truck. Also being the 2004 was a 4 door extended cab, the seats do not slide forwards on their own when you release the seat latch. Everything lines up perfect, exact same seat tracks. I do not want to pay for a new seat belt only to have it fail again.
I had to swap the seat tracks from my original seats onto the 2000 seats. The repair did not remedy the failure. Cela signifie que tous les frais liés à la réparation d'une voiture rappelée par le fabricant sont à la charge du nouveau propriétaire. I have asked the dealer to replace the vehicle, they said I am sorry we already got your check from the bank, and we would not be able to replace this truck. I fitted an 04 4dr Explorer driver seat, but set up to high for my height.