To re-attach, just clip them to the rear deck before you place it back in they hold themselves on. I hear the electric working but it doesn't push up the pin to unlock the door so I have to pull the pin manually. Then I would use the screwdrivers leverage to pop the panel away from the door frame. You've got a couple of longer locating tabs. Apr 10, 2014 You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. When this sucker dies never Cadillac again. Inspect the window for proper operation and a tight seal.
I have just recently experienced problems with my passenger rear window. This video will also help if you need to get the door panel off for other reasons. As I reviewed, the test is pretty detailed. I use a household putty knife, just to pull up on this lock, the little keyway there, and the lock button comes out. Dont worry if you drop the nut as there is a little tray to catch it before it falls into the depths of the car. Otherwise if you have the 3.
Take off the 4 nuts that secure it 10 mm box wrench. Lower the window into the window regulator clamps. Remove the door trim panel screws 2. Hi All ,New to this forum My 2000 Dts, power window. I'm having trouble removing the panel on the door.
Tighten Tighten the screw to 1 N·m 9 lb in. This video is for informational purposes only. It's pretty straightforward replacement job. Please take any advice or information from this video at your own risk. There are four gold screws holding it on.
The window will not roll down, the door will not unlock, and the mirror will not move. I go in underneath and you pry up, and you get it started coming out. I am by no means an expert. I had the exact same problem as you. Use the J 36796 to release the retainers 1 from around the outside edges of the door trim panel. From here, reverse the instructions to put the door release bezel, two screws and their plastic cover, and the manual lock knob back on.
So, open the rear door and start by prying out on a small plastic cover located on the lock tab. Once these are loose, lift the door panel and unhook it from the top of the door. Thank you for the tip. Remove the foam block from the mirror opening. It has a black cover over it, remove the cover and find the corresponding fuse. Aug 15, 2012 not really sure on that one but on most first you will need to remove screw around handle that opens the door that needs to be removed. Replace the speaker in the other door, and test the speakers to make sure they sound correct.
Donate to keep this site live and ad free --- --- --- --- --- --- --- --- For questions or comments email. Now, go to the door lock and pry out a small plastic tab that secures it, as shown in the next picture. Hello Just a couple of things, I had asked on the last post if you have had your battery disconnected recently? The head unit will produce a signal with insignificant distortion, as do most amps. Once thjis is dont you will have access to the switch. So before you tear the doors apart, call the parts department and see if the drivers and passenger's module are the same part number. Gently pull the inside door handle panel down and. I usually use something flat like a small stiff putty knife to help pry door panal lose.
Refer to Trim Panel Replacement - Side Rear Door. Also had 2 or 3 with the insulation torn. I would lean toward the Dash Integration Module since it monitors so many items to include input from the door modules. These fell off when I pulled the deck panel off. Remove the door pull strap retaining screw covers by gently prying them off Fig. Put it back into place and it goes back on like that.
Install the inside door handle bezel 1 by pulling out on handle and pressing bezel into retainer. I always use a still putty knife to help pry panal off. I am wondering if it is the fuse or something else? Please feel free to call us toll-free, 888-844-3393. Also had 2 or 3 with the insulation torn. But you can still control the other window and doors from the driver side. I am thinking its the left rear door module. Have you had your battery disconnected recently? It was due to the control module.
This is required to fully seat the window for adjustment. The door panel itself, is held on by snap in clips, and you will need a small pry bar to pull them from the door try to get as close to, or directly under the clips to prevent them from tearing out of the door panel. Detach the front and rear of the outer panel, then lift it toward the rear to remove it. I really hope help you with this remember rated it Good luck. Spent a few hours trying to figure it out- had primary power and ground. Tighten the bolt 4 to 9 N·m 80 lb in.