Pull up on the seatback recliner lever located on the outboard side of the seat, to return the seatback to its full upright position. To return the seat, lower the seat and ensure that it is fully latched. Push down on the wrench while tightening for increased leverage. Replace the ignition cables 2. The bench seat may also be moved to the second seating position or removed from the vehicle. In a collision you could slide under the seat belt and be seriously or fatally injured.
The table below explains the Lamp Flash options. If any one feature is controlled manually, the remaining features will continue to operate automati- cally. Getting under a jacked-up vehicle is dangerous. They have an extensive range of performance vehicles, as well as lower-priced variants of Chrysler-badged models. Slide the wheel spacer through the center of the wheel and spare tire cover assembly so that the two retainer tabs snap out and engage the spare tire cover on the opposite side.
Vehicles equipped with an automatic trans- mission cannot be started this way. If you have ejected a disc and have not removed it within 15 seconds, it will be reloaded. Do not attempt to push or tow your vehicle to get it Never pour fuel or other flammable liquid into the started. Oil Pressure Warning Light others could be badly burned by steam or boiling This light shows low engine oil pressure. Rotate Tires Inspect the brake linings. Refer to jack engagement locations in the following steps for proper jack placement.
When it comes to classic American automobile manufacture, the name of Dodge is one that will be mentioned time and again by connoisseurs. Warning Light to turn off. If you see any signs of cracking, scuffing, or worn spots, have the brake hoses replaced immediately. The Sentry Key Immobilizer System does not need to be armed or activated. Don't waste time calling around to your local bookstores or waiting for a repair manual to arrive by mail.
If the bulb comes in contact with an oily surface, clean the bulb with rubbing alcohol. Do not place any article under a power seat or impede its ability to move as it may cause damage to the seat controls. Twist the turn signal socket to remove from the Front Fog Light headlight module and pull bulb from socket. When the panic alarm is on, the headlights and park lights will flash, the horn will pulse on and off and the interior lights will turn on. A moving garage door can cause injury to people and Vehicle exhaust contains carbon monoxide, a danger- pets in the path of the door. Rotate the nut to the right approximately 33 turns until the winch mechanism clicks at least three times. Inspect the engine air cleaner filter, replace if nec- essary.
Checking the oil while the vehicle is on level ground will improve the accuracy of the oil level readings. A two point pivot system allows for horizontal and vertical adjustment of the mirror. A warning display above the rear win- dow provides both visible and audible warnings indicat- ing the range of the object. Turn side of your radio faceplate. Everyone in a motor vehicle should be belted at all times.
Rotate Tires Inspect the brake linings. Refer to original equipment or an authorized tire dealer for recommended safe operating speeds, loading and cold tire inflation pressures. Squeeze the socket assembly tabs to remove it from the Rear Tail, Stop, Turn Signal, Side Marker and Back-up Lights housing. It is supplemented by a Warranty Information Booklet and various customer oriented documents. The parking brake should always be applied when the driver is not in the vehicle. Overloading The load carrying components axle, springs, tires, wheels, etc.
It can be removed from the vehicle by pulling the release handle inside the floor console. This center contains maxi fuses, mini fuses and relays. Vehicles equipped with an automatic transmis- sion cannot be started this way. Keep this in mind when checking tire pressure inside a garage, especially in After inspecting or adjusting the tire pressure, al- the winter. Use the recliner only when the vehicle is parked.