Is the inspection result normal? Distortion in picture In the process of fast-forward or fast-reverse. Wire color Description Condition Value Approx. Replace one of the voicetags being confused with a different voicetag. Remove the brake pedal assembly. L Combination switch Replace the combination switch. The daytime screen was set the last time the headlights were turned on. Check continuity between multifunction switch harness connector and ground.
Later, the current location mark may be repositioned to the road if the correct road is detected. Brake booster will not operate normally if the hose is installed in the wrong direction. Loosen the flare nut with a flare nut wrench and separate the brake tube from the brake hose. Just after pressing ignition switch. Adjust the predictive course line cen-ter position of the steering angle sen-sor. Other audio sounds are normal. Disconnect audio unit connector, and connect satellite radio tuner connector.
Is the inspection result normal? Pull up the combination switch to remove it. Check that the symptom does not occur. Is the inspection result normal? Remove snap pin 1 and clevis pin 2 from clevis. During normal operation, the window slightly raises and lowers automatically to prevent any window to vehicle interference. Is the inspection result normal? Brake booster pressure sensor A.
Check continuity between audio unit harness connector and ground. Tighten the flare nut to the specified torque with a flare nut crowfoot and a torque wrench. Therefore, the current location mark may appear on either of them alternately, depending on maneuvering of the steering wheel and configuration of the road, etc. Our 2012 Nissan 370Z repair manuals include all the information you need to repair or service your 2012 370Z, including diagnostic trouble codes, descriptions, probable causes, step-by-step routines, specifications, and a troubleshooting guide. Check the air tight condition again. Only specified switch cannot be operated.
Install the brake tube to the brake hose, temporarily tighten the flare nut by hand until it does not rotate further, and fix the brake hose to the bracket with the lock plate. If problems are encountered, try the following solutions. Set the destination and perform route calculation. Remove trunk lid finisher inner. No sound from all speakers. Check continuity between audio unit harness connector and spiral cable harness connector. Wire color Description Condition Value Approx.
Install the brake pads to the torque member. This entry was posted in and tagged , , on by. Any counts exceeding 50 are ignored. Route calculation has not yet been performed. Technically, it is the sixth generation of Nissan? Check each item of brake pedal.
Remove the lock plate and remove the brake hose. Route guidance is set to off. Off Stops the low beam request signal and the daytime running light request signal transmission. Steering switch signal A circuit. Remove preset switch screws A B to remove preset switch 1 from cluster lid C finisher. Delete Unit Connection Log Erase the connection history of unit and error history.
Satellite radio tuner Ground Condition Reference value Connector Terminal B236 9 When satellite radio mode is selected. Play music data included in trucks from Truck 2. Wipe it off immediately and wash with water if it gets on a painted surface. Connector Terminal B237 29 5. On Parking brake is released.