When you shut off and re-start your vehicle, the transmission will automatically return to normal Overdrive mode. Note: In the illustrations, lightning bolts are used to designate the assisting boosting battery. Reach behind the rear bumper to locate the bulb. Dirty glass is significantly more difficult to defrost, demist, etc. Refer to the scheduled maintenance guide for scheduled maintenance. Starting autoset memory preset 1.
Refer to Tune adjust or Seek function for more information on selecting a station. Notice to owners of pickup trucks and utility type vehicles Utility vehicles have a significantly higher rollover rate than other types of vehicles. Drive provides more engine braking than Overdrive and is useful when:. Hold the control to move through the frequencies quickly. To stop on a particular selection, press the control again. The bars of varying length are for intermittent wipers.
To change the license plate lamp bulbs: 1. Instead, gradually decrease your speed. Ford production and aftermarket Motorcraft oil filters are designed for added engine protection and long life. The fuel gauge may vary slightly when the vehicle is in motion. Be sure to put the cap back on the reservoir. Refer to the garage door opener manual or call 1—800—355—3515 or on the Internet at HomeLink.
If the disc holders are not fully locked into the magazine, the unit will not operate. If the fuel filler cap is venting vapor or if you hear a hissing sound, wait until it stops before completely removing the fuel filler cap. Flash to pass Pull toward you to activate and release to deactivate. When refueling your vehicle after the fuel gauge indicates empty, you might not be able to refuel the full amount of the advertised capacity of the fuel tank due to the empty reserve still present in the tank. Move the gearshift lever to the desired gear. Locate the correct anchor for the selected seating position. Install the throttle body adapter and the four bolts.
Repeated or prolonged skin contact with fuel liquid or vapor causes skin irritation. To provide a tight tether strap: 1. Stow the cross bars in the notches behind the rolled cover in the pickup box. Insert the indicator fully, then remove it again. Improper use of the power outlet can cause damage not covered by your warranty. Department of Transportation requires Ford to give you the following information about tire grades exactly as the government has written it.
Have your tow truck operator refer to this manual for proper hook-up and towing procedures for your vehicle. Locate and carefully remove the engine oil level indicator dipstick. If equipped with a two piece lug wrench, assemble the lug wrench as shown in the illustration. Stage 1: Tighten to 10 Nm 89 lb-in. Start the engine of the disabled vehicle.
Turn the engine off and wait a few minutes for the oil to drain into the oil pan. The decisions of the Board are binding on Ford and, in some cases, on the dealer but not on consumers who are free to pursue other remedies available to them under state or federal law. Transmission operates in gears one through three. If you pull too hard on the disc holder, the disc holder may come completely out of the magazine. Lift the battery with a battery carrier or with your hands on opposite corners. Install the engine air cleaner and the air cleaner outlet tube. If the battery has been disconnected and reconnected, refer to the Battery section of the Maintenance and care chapter.
If your brake warning lamp illuminates, have your vehicle serviced immediately. Connect the negative - cable to the negative - terminal of the assisting battery. The Dolby noise reduction system is manufactured under license from Dolby Laboratories Licensing Corporation. Belt-positioning booster seats raise the child and provide a shorter, firmer seating cushion that encourages safer seating posture and better fit of lap and shoulder belts on the child. To disable one-time or deactivate the Belt Minder feature please follow the directions stated below.
Installing the snowplow Removing the blocker beam without installing snowplow attachment hardware may affect air bag deployment in a crash. Grasp the shoulder portion and pull downward until the entire belt is extracted. Remove the panel cover to access the fuses. Install the accelerator cable bracket and the bolts. Position the power steering reservoir aside. Ensure the correct automatic transmission fluid is used.
Return to the center position to lock mirrors in place. Power steering uses energy from the engine to help steer the vehicle. Ford Motor Company provides a towing manual for all authorized tow truck operators. When starting a fuel-injected engine, avoid pressing the accelerator before or during starting. The locking clip screws below the middle bar can be tightened counterclockwise for extra security.